Download Ructane Driver for Cryptopro

Users of the Cryptopro data protection system are often used as a key of routeen from the company ". However, the latest models of this device do not work without availability in the system of relevant drivers, and today we will tell you where you can download and how to install them.

We load the driver of the Ructane for Cryptopro

The procedure is performed in two stages: installation in the cryptopro module for support of the routeen and, in fact, the installation of the drivers for the specified device.

Step 1: Installing Support Module

Before installing the service software for the USB keys under consideration, it is first necessary to add the support module to the cryptographic protection package. This is done as follows:

1. Go to the module loading page to the SCJi under consideration, located on the official resource of the RUCTEN developers. The modules are presented both for CSP and for the JSP version of the cryptopro, the first version is also separated by bit. To download the desired component, simply click on its name.



2. To continue the download, you will need to accept the license agreement - read the document, then check the "Terms of the License Agreement" read and received in full "and click on the" Conditions Accepted "button.



3. Load the module installer to any suitable location, then run the executable file. Press "Next" in the first window "Installation Wizard".



4. In the next step, click "Set".



5. Installation occurs in automatic mode, because it is just wait for the end of the procedure.

   

   To close the installer, click Finish.

At this, the first stage is completed and you can go to the next one.

Step 2: Install Driver

After installing the support module, you can install directly driver.

1. Go to the Ructane Driver Loading page. There is only one installation package - click on his name.



2. This time you will not have to receive a license agreement - after loading the next page, the installation file will automatically begin. Save it to a suitable directory.
3. At the end, go to the directory with the downloaded installer and run it. Check if the item is noted about adding the driver management label to the "desktop", and click "Set".



4. The software installation procedure will begin. As a rule, it does not last longer than 5-10 minutes.



5. When the installation is over, use the Close button to complete the installer.

On this, our today's task is solved - installation of route drivers for cryptopro is fully fulfilled.