How to fix the error "DNS PROBE FINISHED NO Internet" in Windows 10

Method 1: Reloading the router and computer

The failed failure appears as a result of the incorrectly specific DNS parameters, which most of them arises due to difficulties in the work of the router. To begin with, try to restart it - despite its simplicity, this procedure is able to solve a number of small problems.

Read more: Reloading the router

Also, the computer will also be easily restarting: Windows software errors sometimes cause the message "DNS Probe Not Finished".

Read more: Methods of rebooting Windows 10

Method 2: Launch DNS service

If the failure does not disappear after restarting the PC and the router, it is possible in the incorrectly running DNS system service. To eliminate the problem as follows:

1. Open the "Run" using the Win + R keys, then enter the Services.msc request and click "OK".



2. After opening the snap-in, look for an entry with the name "DNS client" in the list, click on it right-click and select "Properties".



3. The launch status of the service must be designated as "automatically", and she herself is performed. If this is not so, using the drop-down menu, select the desired option, then click "Run", "Apply" and "OK".



Close all open snapshots and check the error - if the case was in the DNS client, it should aby.

Method 3: Reset DNS Parameters

It can also be a cache error mentioned in the previous method of the system client. It is recommended to clean it, including for diagnostic purposes, according to the following algorithm:

1. We will need a "command line" running on behalf of the administrator. In the "dozen" most simple method to do this will be the use of "Search": Open it, type the command in the line, then select the result found and click on the "Run from the administrator name" in the right menu.

   

   See also: How to open a "command line" from the administrator in Windows 10

2. After the command input interface appears, type the operator below and press ENTER.

   Ipconfig / Flushdns.



3. After receiving a message about a successful reset, close the "command line".



Open the browser and try to cross the different pages - the problem must be eliminated.

Method 4: Change network profile

In some cases, the cause of failures becomes the inconsistency of the network profile, and it is worth changing it. The procedure refers to elementary, but if you are experiencing problems with its execution, use the manual further.

Read more: How to change network type in Windows 10

Method 5: Installing Alternative DNS

It is possible that the situation may occur due to DNS failures on the side of the provider. The removal method in such a situation is to install public addresses, such as Google.

1. Use the "Run" means (see page 1 of the second method), where enter the NCPA.CPL command.



2. Find the connection in the list that is used to communicate with the Internet, click on it with PCM, and select "Properties".



3. In the properties menu, select the TCP / IPv4 protocol position and click "Properties".



4. Activate the "Use the following DNS addresses" option and enter such values:

   8.8.8.8.

   8.8.4.4.

   Check the input correctness, then click OK.



After turning on these options, the error must be eliminated.

Method 6: Reset network settings

In the most extreme case, when no option helps, it is worth using a radical measure - a complete reset of custom connection settings.

1. Press the Win + I key combination to call the "parameters" snap-in, in which you select "Network and Internet".



2. Click the Status tab where you use the link "Relief".



3. Next, click "Reset Now."



4. Close all unlocked programs and confirm reboot.

After this operation, all connections to the Internet will be needed to configure again - use the instructions from the following article.

Read more: Internet Configuration Guide in Windows 10