How to open a samsung phone cover

Models with removable lid

Smartphones of all episodes, released before 2017, for the most part possess the collapsible body, so the task is greatly simplified for them. You will need only a guitar mediator or plastic card.

1. If your device has a tray for SIM / memory cards, first remove it.



2. Carefully inspect the gadget housing - on one of the faces there must be a groove. Insert the mediator there, the angle of the card or simply picker the nail and take carefully up.



3. Carefully walk around the faces, squeezing the cover from fasteners - in most cases it should be without difficulty.



4. After completing this action, the lid must move by opening access to the battery and / or slots for SD and SIM cards.



As you can see, the operation for such Samsung elementary models.

Models with a beam lid

Since 2018, Samsung, following the generally accepted trend manufacturers, has moved to the creation of devices whose buildings are not intended to be disassembled independently. In such models (and at the time of this writing this article, most in all rules) the back cover is either glued to the body with a special composition, or is one piece with the main chassis. In the first case, it is not easy to dischanging the desired element at home, but it is possible, whereas in the second can not do without a visit to a specialist. To determine, use the search on the Internet: Open your preferred search engine in which you enter the query * The name of your smartphone model * Disassembly, then read the instructions. If they say that the disassembly is made through the screen - alas, but they will have to go into the SC, but if the opening of the body is mentioned, you have chances.

Attention! Further actions, you do on your own risk - we are not responsible for the possible way out of the order as a whole and individual items!

1. To fulfill the operation under consideration, we will need the following:
   • Hair dryer - suitable as a special for soldering, and construction, plus can be used and household, for drying hair;
   • Mediator, thin plastic card or plastic blade;
   • the suction cup with which it will be possible to disconnect the lid;
   • non-aggressive solvent-electronics - a means for cleaning plates with isopropanol in composition and / or pure gasoline (for example, "Calosha" or its analog);
   • Two-way scotch or adhesive or a special sealant to which the cover will be glued back.



2. Turn on the hair dryer and set the temperature and flow to medium (soldering and construction equipment) or at full power (household) and heat the joints and the corners of the back of the device housing - this must be done to soften the adhesive composition. It should be heated not more than 2-3 minutes.



3. Check if the clearance appeared between the lid and frame - if so, insert the mediator or plastic card into it, if not, warm the edge is some more, but not more than a minute. You can also add a solvent that removes the remnants of the glue.
4. Attach the suction cup in the back cover (preferably - approximately in the center), then swipe the plastic tool on the seam, separating the elements from each other and at the same time pull for the suction cup on yourself.

   Attention! Do not apply too much effort, especially for devices that have a fingerprint scanner on the back cover!



5. The lid should be disconnected. Disconnect all the loops from the housing, if any will be detected.



6. In order to set the part back, make sure that all the loops are connected, then you must remove the remains of the old glue from the connection points, degrease the appropriate solvent places, impose a tape or glue, and then press the items to each other. It is also recommended to use plastic clamps or hair gums, with which the device should be recorded for a period of several hours before the day (depends on the adhesive composition used).

If this instruction seemed difficult to you or you are not sure about your skills, do not risk better and take the device to those skilled in the art.